SYS Griptape

To provide grip, you need friction. The degree of friction is increasing with the roughness of the aligning materials. Standard griptape provides friction through grains of quartz sand. Quartz sand is normally a hard, sharp-edged and pointy material. When such material meets one which is considerably softer, it provides a high degree friction. Perfect for shredding purposes. Unfortunately this friction causes a high degree of abrasion at the same time. The friction caused by interlocking grains with the material of your shoes tears apart parts of your shoe every time you do a trick. And sooner than later you will have the first holes and fuzzy laces.

How is SYS-Grip different?

We don’t use grains of quartz sand, but synthetic fiber. This fiber is cut into tiny blocks applied vertically to the griptape. The single fibers are not much bigger than a grain of sand, but a lot thinner. The vertically applied fibers cause the same friction like quartz sand.

And now to the important part:

Unlike quartz sand our fibers are considerably softer, that’s why we need 100 times more fibers on a griptape than grains of sand on a standard grip. That means that the fibers don’t rip up your shoes, but the shoe slowly destroys the fibers. This way a high degree of friction is provided, but your shoes will last significantly longer.

If you don’t buy a deck with the gripjob nose and tail we will ship you 2 uncut seperate sheets of griptape with the wave cut on 1 side. You will have to apply the grip and cut off the shape of your nose and tail yourself.
If you don’t buy a deck with the gripjob full board we will ship you a sheet of griptape 28cm by 130 cm. You will have to apply the grip and cut off the shape of your board yourself.